Amazon Black Friday Week deals

Paid link

How-to · Shower Filters

How to Replace a Shower Filter

Short answer

To replace a shower filter, unscrew the shower head from the arm, pull out the old cartridge, slide the new one in, and screw the head back on. The swap takes a few minutes. Check the joint for drips when you run the water again.

  1. Turn the water off and unscrew the head

    Turn the shower off, then unscrew the shower head from the arm by hand and set it aside. Hold the arm steady with your other hand while you turn the head, so the arm does not move. Put a towel under the joint to catch the water left in the head.

  2. Take out the old cartridge

    Pull the old cartridge out of the filter housing and set it aside. Look at the washer where the head meets the arm, and swap in a fresh one if it looks worn or flat. The Aquabliss filter comes with replacement washers, so keep one ready before you start.

  3. Fit the new cartridge

    Slide the new cartridge into the housing the same way the old one sat, and press it in until it sits flat. The Aquabliss cartridge fits either direction, so it goes in either way round. Check that the washer sits in place behind the cartridge before you put the head back on.

  4. Screw the head back on

    Wind thread seal tape on the arm threads if the new filter came with it, then screw the shower head back on by hand. Tighten it snug and stop there, since over-tightening can cause leaking. Wipe the joint dry so you can spot any drips when the water runs.

  5. Run the water and check for drips

    Turn the shower on and let the water run, then look at the joint for drips. If you see a drip, turn the water off, tighten the head a little more by hand, and check again. If it still drips, take the head off and check the washer and the tape before you refit it.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Shower Head Filter, which compares them spec by spec.

FAQ

How often should I replace a shower filter?

The Aquabliss cartridge lasts 3 to 6 months, and the MyHalos filter lasts up to 90 days. Replace the cartridge sooner if your lather feels flatter, and follow the schedule in the maker's manual.

Do I need tools to replace a shower filter?

No. The Aquabliss cartridge swaps with no tools in about two minutes, and the MyHalos head fits standard fixtures with no tools. Keep the new cartridge and the thread seal tape ready before you start.

What if the joint drips after I swap the filter?

Turn the water off and tighten the head a little more by hand, then run the water and check again. If it still drips, take the head off, check the washer and the tape, and refit the head snug without over-tightening.

More shower filters how-tos