Amazon Black Friday Week deals

Paid link

How-to · Above Ground Pools

How to Clean an Above Ground Pool Without a Pump

Short answer

To clean an above ground pool without a pump, skim leaves off the surface, brush the walls and floor, and vacuum the bottom with a garden hose siphon. Scoop out what settles, then drain and refill the pool if the water stays dirty. A cover keeps leaves out between cleanings, so the next cleaning starts with less work.

  1. Skim leaves off the surface

    Start with a skimmer net on a pole and pull leaves, insects and other floating debris off the surface. Work from one end of the pool to the other so nothing drifts past you. Empty the net into a bucket as it fills, and keep going until the surface looks clear. Skimming first keeps debris from sinking to the floor, where it takes more work to remove.

  2. Brush the walls and floor

    Use a pool brush on a pole to scrub the walls from the waterline down, then brush the floor toward one end. Brushing lifts dirt and debris off the liner so it settles where you can vacuum it up. Pay attention to corners and seams, where debris gathers. Brush before you vacuum, so the loosened dirt has a chance to settle on the floor.

  3. Vacuum the floor with a siphon

    Push one end of the hose under the water and fill it, then keep that end under the water while you drop the other end outside the pool, lower than the water level, so water starts to flow. Move the hose end slowly across the floor to pick up the dirt that settled there. Keep the hose end under the water so the flow does not break.

  4. Drain and refill if the water stays dirty

    If the water stays cloudy after skimming, brushing and vacuuming, drain the pool and refill it. The Bestway set has a built-in flow control drain valve that takes a garden hose, so attach a hose and let the water run out where it can drain away. Once the pool is empty, wipe the liner with water and a little mild dish soap if the manual allows it, then rinse and refill.

  5. Cover the pool between cleanings

    Put the pool cover on whenever the pool is not in use. A cover keeps leaves and debris out, so the next cleaning starts with less work. Clear leaves off the cover before you take it off, so they do not fall into the water. Check the cover for tears, and patch it as the manual shows so it keeps doing its job.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Above Ground Pool, which compares them spec by spec.

FAQ

Can I clean a pool with no pump at all?

Yes. Skim the surface, brush the walls and floor, and vacuum the bottom with a garden hose siphon. Drain and refill the pool if the water stays dirty after cleaning.

How do I vacuum a pool without a pump?

Use a garden hose as a siphon. Fill the hose with water, keep one end under the water in the pool, and drop the other end outside the pool, lower than the water level. Move the hose end slowly across the floor to pick up settled dirt.

How do I keep the pool cleaner between cleanings?

Put the cover on whenever the pool is not in use, and skim leaves off the surface before they sink. Clear leaves off the cover before you take it off, so they do not fall into the water.

More above ground pools how-tos