Amazon Black Friday Week deals

Paid link

How-to · Canister Vacuums

How to Clean a Vacuum Filter

Short answer

To clean a vacuum filter, unplug the vacuum, take the filter out, and tap it over a trash can until the dust falls out. Rinse it only if the maker's manual says it is washable, and let it dry fully before it goes back in. A filter that stays grey or torn after tapping needs a replacement from the maker.

  1. Unplug the vacuum and find the filter

    Unplug the vacuum from the wall outlet before you open it. Open the canister or the filter compartment the way the maker's manual shows, and lift the filter out by its frame or handle. Note how it sits so you can put it back the same way. Keep the filter over a trash can while you handle it so loose dust falls where you want it.

  2. Tap the dust off the filter

    Hold the filter over a trash can and tap it gently against the side of the can so the dust falls out. Turn the filter and tap each side, then brush loose dust off the pleats with a soft, dry brush if the manual allows it. Do not use a hard tool on the filter material, and do not tap it against a hard surface that could bend the frame.

  3. Rinse only a washable filter

    Rinse a filter only if the maker's manual says it is washable. Hold it under plain water and let the water run through it until the water runs clear, then shake off the extra water. Let the filter dry fully in open air before it goes back in the vacuum. Never put a damp filter back, and never use soap or a cleaner on it unless the manual says to.

  4. Put the filter back and check the fit

    Slide the dry filter back into its compartment the way it sat before, and close the cover until it clicks or sits flush. Plug the vacuum back in and run it for a short check on a small patch of floor. If the suction feels weak or dust escapes from the vacuum, take the filter out again and check that it sits flat with no gaps around the edges.

  5. Replace a filter that stays dirty

    Replace the filter when tapping and rinsing leave it grey, torn, or bent out of shape. Use the maker's own replacement part for your model, and follow the manual for how it fits. Keep a spare filter on hand so you can swap in a dry spare while a washed filter dries. A filter that no longer fits flat in its compartment will not do its job.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Quiet Canister Vacuum, which compares them spec by spec.

FAQ

Can I wash a vacuum filter with water?

Only if the maker's manual says the filter is washable. If it is, rinse it with plain water and let it dry fully before you put it back. If the manual does not call it washable, tap it clean and replace it when it stays dirty.

How do I know the filter needs replacing?

A filter that stays grey or torn after tapping, or a filter that no longer fits flat in its compartment, needs a replacement. Follow the schedule in the maker's manual and use the maker's own part for your model.

Should I unplug the vacuum before cleaning the filter?

Yes. Unplug the vacuum from the wall outlet before you open the filter compartment, and keep it unplugged until the dry filter is back in place and the cover is closed.

More canister vacuums how-tos