How-to · Reverse Osmosis Systems
How to Clean a Reverse Osmosis System
To clean a reverse osmosis system, turn off the water supply, take out the cartridges, wash the housings with water and mild dish soap if the manual allows it, flush the lines, and put the cartridges back or fit new ones. Use only the cleaner the maker names, and follow the schedule in the maker's manual for filter changes.
Turn off the water and drain the system
Turn off the water supply to the system and open the faucet to let the water run out and release the pressure. Put a towel and a pan under the filter housings to catch the water that drains out. Unplug the system if it uses power, and keep the power cord away from the water on the floor.
Take out the cartridges
Open each filter housing in turn and lift out the cartridge inside. Set the cartridges aside in the order they came out, so each one goes back in the same place. Look at each cartridge and housing for dirt and buildup, and note which ones look dirty so you can replace them with the maker's own type.
Wash the housings and flush the lines
Rinse each housing with water and wipe the inside with a cloth. Wash the housings with water and a little mild dish soap if the manual allows it, then rinse them until the water runs clear. Use only the cleaner the maker names, and only as the manual describes it. Flush the lines with water as the manual describes, and let the water run until it runs clear.
Put new filters in and turn the water back on
Put the cleaned or new cartridges back in their housings in the same order they came out, and close each housing by hand. Turn the water supply back on and open the faucet to let the water run. Check each connection for drips, and tighten a housing by hand if it drips. Run the system as the manual describes before you use the water for drinking and cooking.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
Electrolux PureOne 1200GPD Tankless Reverse Osmosis Under
Its single all-in-one RO filter has 12 stages and one cartridge to replace, and the app schedules automatic filter flushing to help reduce mineral buildup.
View on Amazon -
iSpring RCC7AK-BN NSF Certified
Its transparent first-stage filter housing lets you see contaminant buildup, and its 6-stage system is certified to NSF/ANSI 58.
View on Amazon -
Waterdrop G5P500A Reverse Osmosis System
Its tankless design has 2 pre-installed filters and 8 stages of filtration, certified to NSF/ANSI 58 and 372.
View on Amazon -
APEC Water ROES-50
Its 5-stage system uses quick connection fittings and colored tubing, and the maker recommends replacing filters every 6 to 24 months.
View on Amazon
These come from our ranked list Best Reverse Osmosis, which compares them spec by spec.
FAQ
Can I use vinegar to clean a reverse osmosis system?
Only if the maker's manual allows it. Use only the cleaner or sanitizer the maker names, and follow the manual for the membrane and the housings. Rinse with water and flush the system before you turn the water back on.
How often should I change the filters?
Follow the schedule in the maker's manual, and check the filter housings for buildup. The APEC system recommends filter changes every 6 to 24 months based on incoming water quality, and the iSpring system has a transparent first-stage housing for checking buildup.
Do I need to clean the membrane too?
The membrane is one of the cartridges in these systems. Follow the manual for flushing and replacement, and replace the cartridge when the manual says to.




![[Dual Flow] Waterdrop WD-T4-A Alkaline pH+ Reverse](https://m.media-amazon.com/images/I/719YgI8NGvL._SL1500_.jpg)