How-to · Window Air Conditioners
How to Clean Styrofoam in a Window AC
To clean the styrofoam in a window air conditioner, unplug the unit and follow the maker's manual to open the front panel and reach the styrofoam. Brush off loose dust, then wipe the surface with a soft cloth dampened with water and a little mild dish soap if the manual allows it. Let the styrofoam dry fully before you close the unit and plug it back in.
Unplug the unit and open it
Unplug the air conditioner from the outlet before you touch any part inside it. Follow the maker's manual to remove the front panel and the filter so you can reach the styrofoam. Work with the unit still in the window if the manual says to leave it there, and keep the manual open while you work. If a part will not come off, stop and follow the manual or contact the maker.
Brush off loose dust
Use a soft brush or a dry, soft cloth to lift loose dust from the styrofoam. Work from the top down so dust falls away from the parts you have already wiped. Move the brush in light strokes and press only as much as the surface needs, since styrofoam dents and crumbles when it is pressed hard. Shake the dust out of the cloth often, and brush the filter while you have it out.
Wipe with water and mild soap
Dampen a soft cloth with water and wring it out so it is barely wet. Wipe the styrofoam in light passes, and add a little mild dish soap to the cloth only if the manual allows it. Rinse the cloth in clean water and wipe again to lift the soap. Never mix cleaners, and never use bleach or a rough pad on the styrofoam.
Let it dry and put it back
Leave the front panel off and let the styrofoam dry fully before you close the unit. Wipe any water from the inside of the case with a dry cloth, and check that the filter is dry before it goes back in. Refit the filter and the front panel as the manual shows, then plug the unit back in. If the styrofoam is cracked or a piece has come loose, contact the maker or a repair service.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
GE Window Air Conditioner
A 5,000 BTU unit rated for up to 150 sq ft by the maker, with a washable, reusable filter and two cooling modes.
View on Amazon -
Frigidaire 6,000 BTU Window Air Conditioner
A 6,000 BTU unit rated for up to 250 sq ft by the maker, with a remote control, Eco Mode, and a washable dust filter with Clean Filter alerts.
View on Amazon -
ROVSUN 8000 BTU Window Air Conditioner
An 8,000 BTU unit rated for up to 350 sq ft by the maker, with cool, heat, dehumidify and fan modes, app and voice control, and a washable filter.
View on Amazon -
Amazon Renewed Midea 5,000 BTU 150 Sq ft Mechanical
A 5,000 BTU unit rated for up to 150 sq ft by the maker, with two cooling modes, two fan speeds, and seven temperature settings.
View on Amazon
These come from our ranked list Best Window AC Unit, which compares them spec by spec.
FAQ
Can I use bleach on the styrofoam?
No. Use water and a little mild dish soap only if the manual allows it, and never mix cleaners. Bleach and rough pads can damage the styrofoam surface.
Should I take the styrofoam out to clean it?
Leave it in place and clean it where it sits, following the maker's manual. If a piece is cracked or loose, contact the maker or a repair service.
What if the styrofoam still looks dirty after wiping?
Wipe it again with a damp cloth and a little mild dish soap if the manual allows it, then let it dry fully. Check the filter too, and clean it as the manual shows.





