How-to · Water Softeners
How to Fill a Water Softener with Salt
To fill a water softener with salt, lift the lid off the brine tank and check how much salt is left, then add the salt type your maker's manual names until the salt sits above the water in the tank. Replace the lid and start a regeneration from the control head if your model offers one, so the fresh salt is ready for the next cycle.
Check the salt level first
Lift the lid off the brine tank and look inside. The salt should sit above the water in the tank, with dry salt visible on top. If the salt has dropped below the water line, or the tank looks empty, it is time to add more. Push a broom handle gently through the salt to check for a hard crust, called a salt bridge, that holds salt above the water while the tank below runs low.
Use the salt your manual names
Buy that form and check the bag for damage before you open it, so damp or clumped salt does not go into the tank. Keep the bag closed and stored in a dry spot until you need it, and pour from the bag rather than scooping with a dirty container.
Pour salt into the brine tank
Open the brine tank lid and pour the salt in slowly, keeping it away from the brine well tube if your tank has one. Stop when the salt sits above the water line with dry salt on top, and do not pack the salt down, since packed salt can form a crust. Wipe spilled salt off the rim and the floor around the tank, then put the lid back on so dust and dirt stay out.
Start a regeneration cycle
After the tank is filled, start a manual regeneration from the control head if your model offers one, so the fresh salt mixes into brine and the resin bed recharges. Watch for the cycle to run through its stages and finish before you use hot water. If the control head shows an error or the cycle will not start, check the manual and contact the maker or a repair service.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
Aquasure Harmony Series
Its automatic digital metered control head lets you set auto-flush intervals, and it is rated at 32,000 grains for 1-2 bathrooms.
View on Amazon -
Tier1 32,000 Grain Water Softener System
Its metered regeneration control starts a cycle only when household demand calls for it, and its salt tank measures 13.5 by 32 inches.
View on Amazon -
Superior Filters Whole House Water Softener System
Its 32,000-grain resin capacity extends the time between regeneration cycles, conserving salt and water.
View on Amazon -
H&G Lifestyles Whole House Water Softener
Its 24,000-grain resin is rated for 700,000 gallons, and it uses NSF certified food grade resin with a 10 percent crosslink.
View on Amazon
These come from our ranked list Best Home Water Softener, which compares them spec by spec.
FAQ
How do I know when to add salt?
Look in the brine tank and check whether dry salt still sits above the water. If the salt has dropped below the water line, or the tank looks empty, add the salt form your maker's manual names.
What is a salt bridge in a water softener?
A salt bridge is a hard crust of salt that forms above the water in the brine tank and stops salt below it from dissolving. Break it up gently with a long handle, remove the loose pieces, and add fresh salt if the level is low.
Can I use any kind of salt?
No. Other salts can clump, leave residue or fail to dissolve the way the softener expects, so check the bag before you pour it in.





