How-to · Robotic Pool Cleaners
How to Get Sand Out of an Above Ground Pool
Sand settles on the floor of an above ground pool, so a cordless robotic cleaner that runs along the floor picks it up. Let the water settle, run the cleaner over the floor, then lift it out and clean out the collected debris. For sand left in corners, brush it toward the cleaner path and run another cycle.
Let the water settle first
Stop swimming and let the pool sit until the water is still and the sand has settled on the floor. Wait until you can see where the sand sits before you start the cleaner, so the cleaner runs over the sand instead of stirring it up.
Run the cleaner over the floor
Place the cordless cleaner on the pool floor and start a cleaning cycle. The WYBOT B1 runs for up to 125 minutes and covers pools up to 1,220 sq. ft., with Floor, Wall, Waterline and Combo modes. The BRINBO S2 runs for up to 90 minutes and covers pools up to 861 sq. ft. Let the cleaner finish the cycle before you lift it out.
Pick a cleaner that fits the pool
Match the cleaner to the pool size. The OUCAXIA Y10 covers pools up to 1300 sq. ft. on a single charge, with a 150-minute run time. The Aiper Scuba SE covers pools up to 860 sq. ft. with a 90-minute run time. Check the coverage figure against the pool before you buy.
Clean the filter after each run
Lift the cleaner out of the pool and open the filter. The BRINBO S2 has dual-layer filtration that captures leaves and finer dirt, and its filter can be cleaned easily after each use. The OUCAXIA Y10 has a 2.2L filter basket with an easy-access, quick-rinse design. Rinse the filter with water and put it back before the next run.
Catch sand in corners and along walls
Sand gathers along walls and in corners where the cleaner may not reach. The WYBOT B1 has a six-roller brush with edge-to-edge cleaning for walls, corners and hard-to-reach areas. Brush loose sand from the walls and corners onto the open floor, then run the cleaner again so it can pick the sand up.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
WYBOT B1 Cordless Robotic Pool Vacuum
Its triple-motor suction captures sand, dirt and fine debris, with a six-roller brush, Floor, Wall, Waterline and Combo modes, and up to 125 minutes of run time.
View on Amazon -
BRINBO S2 Pool Vacuum Robot for Above Ground
Its dual-layer filtration captures leaves, dirt and sand, with up to 90 minutes of run time and coverage for pools up to 861 sq. ft.
View on Amazon -
2026 Aiper Scuba SE Cordless Pool Vacuum
Its dual-cleaning modes cover daily or deep cleans, with 1820GPH suction, a 90-minute run time and self-parking at the pool edge.
View on Amazon -
OUCAXIA Y10 Robotic Pool Cleaner
Its dual suction inlets capture sand, dirt and fine debris, with a 150-minute run time, a 2.2L filter basket and self-parking.
View on Amazon
These come from our ranked list Best Above Ground Pool Vacuum, which compares them spec by spec.
FAQ
Can a robotic pool cleaner pick up sand?
Yes. The WYBOT B1, BRINBO S2 and OUCAXIA Y10 all capture sand from the pool floor, and the WYBOT B1 also cleans walls and the waterline.
How long does a cordless pool cleaner run?
The WYBOT B1 runs for up to 125 minutes, the BRINBO S2 and Aiper Scuba SE for up to 90 minutes, and the OUCAXIA Y10 for 150 minutes.
Do I need to plug in a cordless pool cleaner?
No. All four cleaners are cordless and run on battery power, so you place the cleaner in the pool and start the cycle with no cord in the water.
What size pool can these cleaners cover?
The WYBOT B1 covers pools up to 1,220 sq. ft., the BRINBO S2 up to 861 sq. ft., the Aiper Scuba SE up to 860 sq. ft., and the OUCAXIA Y10 up to 1300 sq. ft.



