Amazon Black Friday Week deals

Paid link

How-to · Robotic Pool Cleaners

How to Use a Pool Vacuum With a Sand Filter

Short answer

To use a pool vacuum with a sand filter, prime the vacuum hose with water, connect it to the skimmer, and set the filter valve to filter. Vacuum the pool floor in slow, overlapping passes so the filter traps the dirt. When you finish, turn the pump off, set the valve to backwash and rinse as the filter manual says, then return it to filter.

  1. Prime the hose and connect it

    Set the filter valve to filter and turn the pump on so water is moving through the system. Hold the vacuum head and hose under water and push the hose down a section at a time until the hose is full of water and no air bubbles rise. Connect the free end of the hose to the skimmer, keeping the hose under water so air stays out. Air in the hose makes the pump lose prime, so check that the pump basket stays full of water.

  2. Vacuum the floor in slow passes

    Move the vacuum head across the pool floor in slow, overlapping passes, working from the shallow end toward the deep end. Keep the head flat on the floor and pause over piles of leaves and sand so the suction can lift them. If the head lifts off the floor, push it back down and slow your pace. Watch the pump basket and the filter pressure gauge as you work, and stop to empty the basket when it fills with leaves.

  3. Backwash and rinse the filter

    When the floor is clean, turn the pump off and set the filter valve to backwash. Turn the pump on and let water run out the waste line until it runs clear, then turn the pump off and set the valve to rinse. Run the pump on rinse until the water in the sight glass runs clear, then turn the pump off and return the valve to filter. Follow the schedule in the filter maker's manual for how often to backwash.

  4. Empty the baskets and store the hose

    Turn the pump off and empty the skimmer basket and the pump basket, rinsing each with water from a garden hose. Coil the vacuum hose in wide loops so it does not kink, and store the vacuum head and hose out of direct sun. Check the filter valve handle and the hose ends for cracks before the next use, and contact the maker or a repair service for a fault inside the pump or the filter.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Pool Vacuum for Sand, which compares them spec by spec.

FAQ

Can I vacuum to waste with a sand filter?

Yes, if your filter valve has a waste setting. Turn the pump off, set the valve to waste, and vacuum so the dirt leaves through the waste line instead of passing through the sand. Top up the pool water after, since waste mode sends water out of the pool.

Why does my vacuum lose suction?

Air in the hose is the first thing to check. Push the hose under water until no bubbles rise, keep the hose end under water at the skimmer, and empty the pump basket when it fills. A filter that needs backwashing can also slow the flow, so follow the manual.

How often should I backwash the sand filter?

Watch the filter pressure gauge and the flow from the returns. When the pressure reads high against the clean reading, or the flow drops, backwash and rinse as the manual says. Follow the schedule in the filter maker's manual.

More robotic pool cleaners how-tos