Amazon Black Friday Week deals

Paid link

How-to · Robotic Pool Cleaners

How to Vacuum a Pool With a Cartridge Filter

Short answer

To vacuum a pool with a cartridge filter, connect a vacuum head and hose to the skimmer, prime the hose with pool water, and run the pump so debris is pulled into the cartridge. Vacuum the floor in slow, overlapping passes, then clean the cartridge when suction drops. A robotic cleaner can handle the same job on its own.

  1. Skim and brush first

    Scoop leaves and large debris off the surface with a skimmer net, and brush the walls and floor toward the main drain before you vacuum. Debris left in the pool clogs the vacuum head and fills the cartridge sooner, so clearing it first keeps suction up through the job. Empty the skimmer basket and the pump basket before you start.

  2. Connect the vacuum head and hose

    Push the vacuum head onto the pole and connect the hose to the head. Lower the head and hose into the pool, and hold the free end of the hose against a return jet until water runs out of it and no air bubbles rise. Connect the hose to the skimmer inlet and keep the hose end under water so air stays out of the line.

  3. Vacuum in slow, overlapping passes

    Walk the vacuum head across the floor in slow, straight passes that overlap a little, moving from the shallow end toward the deep end. Let the head sit on the floor and move it at a steady pace, since moving it too quickly stirs debris up instead of pulling it in. Work around steps and corners last, and pause when the head loses suction.

  4. Watch suction and clean the cartridge

    When suction drops, the return flow weakens or the filter gauge climbs, stop vacuuming and clean the cartridge. Switch the pump off, lift the cartridge out of the filter tank, and rinse it with a garden hose from top to bottom until the water runs clear. Put the cartridge back as the manual says, and follow the schedule in the maker's manual for how often to clean it.

  5. Let a robot clean between manual vacuums

    A robotic cleaner runs the same job on its own, covering the floor, walls and waterline while it moves around the pool. Set it in the pool, pick a mode in the app where the model has one, and lift it out when the run ends. The four cleaners below bring different features to this job, so match the cleaner to the size of your pool.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Pool Vacuum, which compares them spec by spec.

FAQ

Do I need to backwash a cartridge filter after vacuuming?

No. Lift the cartridge out, rinse it with a garden hose, and put it back as the manual says. Clean it when suction drops or the return flow weakens.

Why does my pool vacuum lose suction?

Air in the hose, a full skimmer basket or a dirty cartridge can each cut suction. Check the hose connection and the baskets, then clean the cartridge as the manual says. If suction stays low, check the pump basket and the filter tank lid seal.

Can a robotic cleaner replace manual vacuuming?

It can handle daily cleaning on its own, covering the floor, walls and waterline. Manual vacuuming still helps for heavy debris after a storm or leaves that a robot misses. Use the robot for routine cleaning and the manual vacuum when debris piles up.

More robotic pool cleaners how-tos