How-to · Pool Pumps
How to Clean an Above Ground Pool Cartridge Filter
To clean an above ground pool cartridge filter, switch off the pump, lift the cartridge out of its housing, rinse it with a garden hose, and let it dry before it goes back in. Rinse between every pleat so dirt and debris wash out, and check the cartridge for tears before you refit it. The steps below cover switching off, removing, rinsing, drying and refitting.
Switch off the pump first
Switch off the pump and unplug it before you open the filter housing. Water under pressure can spray out when the housing opens, so let the pressure drop first. Check the pressure gauge on the filter tank if your system has one, and wait until the needle sits at rest.
Lift out the cartridge
Open the filter housing and lift the cartridge straight out, keeping it upright so trapped dirt stays inside the pleats. Set it on a clean surface where the rinse water can drain away. Note how the cartridge sits in the housing so it goes back the same way.
Rinse between every pleat
Rinse the cartridge with a garden hose, working from the top down and opening each pleat with your fingers so the water reaches the dirt inside. Turn the cartridge as you go so every side gets rinsed. Keep rinsing until the water runs clear from the pleats.
Soak only if the manual allows it
If the cartridge still looks dirty after rinsing, soak it in clean water with mild dish soap, but only if the manual allows it. Never mix cleaners, and never add pool chemicals to the soak water. Rinse the cartridge again with the hose after soaking, so no soap stays in the pleats.
Check it and refit it
Let rinse water drain from the pleats before the cartridge goes back in the housing. Check the pleats for tears and the end caps for cracks, and replace the cartridge if you find damage. Refit the cartridge the way it sat before, close the housing, and switch the pump back on.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
VEVOR Swimming Pool Pump 1.5 HP
A 1.5 HP single-speed pump that circulates pool water at a 5,280 GPH max flow, with a detachable strainer basket and a transparent lid.
View on Amazon -
Doheny's 1.5 HP Above Ground Swimming Pool
A 1.5 HP above ground pool pump that circulates pool water at 83 GPM, with a stainless steel shaft and a 6-foot cord.
View on Amazon -
XtremepowerUS 16" Sand Filter Pump for Above
A 3/4 HP sand filter pump that filters pool water at 3,100 GPH, with a 6-way multi-port valve, a pressure gauge, and a 24-hour timer.
View on Amazon -
FOTING 2026New 13" Sand Filter Pump with 24H
A 1 HP sand filter pump that filters pool water at 3,800 GPH, with a 7-way valve, a pressure gauge, a 24-hour timer, and a 3-year warranty.
View on Amazon
These come from our ranked list Best Above Ground Pool Pump, which compares them spec by spec.
FAQ
How do I know the cartridge needs cleaning?
Watch the pressure gauge and the water flow. A rising gauge reading, slower flow from the returns, or a cartridge that looks dirty are signs to clean it. Follow the schedule in the maker's manual.
Can I use a pressure washer on the cartridge?
No. Use a garden hose with a normal spray nozzle, and rinse between the pleats by hand. A strong jet can tear the pleats and damage the cartridge.
Should I clean the strainer basket too?
Yes. Lift out the basket and empty the leaves and debris, then rinse it with the hose. The VEVOR pump has a detachable basket with a transparent lid, so you can see when it needs cleaning.



