Amazon Black Friday Week deals

Paid link

How-to · Pool Pumps

How to Clean a Pool Sand Filter

Short answer

To clean a sand filter for an above ground pool, switch the pump off, turn the multi-port valve to backwash, and run the pump until the water runs clear. Then turn the valve to rinse, run the pump again, and return the valve to filter. Check the strainer basket and the pressure gauge, and follow the schedule in the maker's manual.

  1. Switch the pump off

    Switch the pump off before you move the multi-port valve. Moving the valve while the pump runs can damage the valve, so wait until the pump has stopped completely. Read the maker's manual for the valve positions and the cleaning steps for your own unit, since controls and valves differ from unit to unit.

  2. Backwash the sand filter

    Turn the multi-port valve to backwash and switch the pump on. Water flows out through the waste outlet and carries dirt out of the sand in the filter tank. Watch the water as it leaves the filter, and switch the pump off when the water runs clear. Follow the maker's manual for the backwash steps for your own unit.

  3. Rinse the filter after backwashing

    Turn the multi-port valve to rinse and switch the pump on again. Rinsing settles the sand back in place and carries out dirt left behind by backwashing. Watch the water as it leaves the filter, and switch the pump off when the water runs clear. Then turn the valve back to filter for normal use.

  4. Clean the strainer basket

    Switch the pump off, lift the lid from the pump, and take out the strainer basket. Empty the basket over a trash can, rinse it with water, and check it for leaves and other debris caught in the mesh. Put the basket back in place and replace the lid before you switch the pump on again.

  5. Check the pressure gauge

    Look at the pressure gauge on the filter before and after backwashing. A gauge reading that rises and water flow that drops are signs the filter needs backwashing again, following the maker's manual. If the gauge reading stays high after backwashing, read the maker's manual or contact the maker or a repair service.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Above Ground Pool Pump, which compares them spec by spec.

FAQ

How do I know the sand filter needs backwashing?

Watch the pressure gauge and the water flow. A gauge reading that rises and flow that drops are signs the filter needs backwashing, following the schedule in the maker's manual.

What does the rinse setting do after backwashing?

Rinse settles the sand back in place and carries out dirt left behind by backwashing. Run it until the water runs clear, then turn the valve back to filter.

Do I need to take the sand out to clean the filter?

No. Backwashing and rinsing clean the sand in place. If the filter still does not work as it did before, read the maker's manual or contact the maker or a repair service.

Can I move the valve while the pump runs?

No. Switch the pump off before you move the multi-port valve, and wait until the pump has stopped. Moving the valve while the pump runs can damage the valve.

More pool pumps how-tos