Amazon Black Friday Week deals

Paid link

How-to · Tankless Water Heaters

How a Tankless Water Heater Heats Water

Short answer

A tankless water heater heats water only when a tap opens, passing cold water through a heat exchanger warmed by gas combustion. Opening a tap starts the burner, and the burner adjusts to hold the set temperature as water flows through. There is no tank to keep hot, so the heater runs only while water is flowing.

  1. Water flows through a heat exchanger

    When you open a hot tap, cold water enters the heater and moves through a heat exchanger that the gas flame heats. The water picks up heat as it passes through, then leaves the heater and runs to the tap. The Westinghouse unit has a copper heat exchanger. Nothing is stored, so the water at the tap is heated as it flows.

  2. The burner matches the flow

    The burner does not run at one level. It adjusts its output to the amount of water moving through the heater, so a small flow at one tap gets less heat than a large flow at several taps. The MIZUDO unit holds the temperature within plus or minus 1 degree Fahrenheit, and the Rheem and Westinghouse units hold it within plus or minus 1 degree Fahrenheit too. The MIZUDO unit starts heating at a flow as low as 0.53 GPM.

  3. Flow rate sets how many taps run

    Flow rate, measured in GPM, is how much hot water the heater can supply at once. The Rheem unit is rated at 7.0 GPM and serves 2 to 3 showers at once, the Westinghouse unit is rated at 7.9 GPM for 3 to 5 fixtures, the Rinnai unit is rated at 10 GPM for 6 fixtures at once, and the MIZUDO unit is rated at 10.3 GPM for 5 to 7 outlets. If the taps ask for more water than the heater can heat, the water at each tap runs cooler. Check the maker's rated GPM against the taps you run at the same time.

  4. Temperature and controls

    You set the outlet temperature on the heater's panel or in its app. The MIZUDO unit adjusts from 95 to 149 degrees Fahrenheit with a default of 107 degrees Fahrenheit, and the Rheem, MIZUDO and Westinghouse units list temperature control. The Rinnai unit works indoors or outdoors and runs on natural gas or propane, and its WiFi control needs a separate module. Follow the maker's manual for settings and installation.

  5. What the vent and drain do

    Gas combustion makes exhaust, and the heater vents it outside. The Rheem unit uses a direct vent system, and the MIZUDO unit uses a sealed concentric direct-vent system with a forced-draft fan. The Rinnai unit installs indoors or outdoors with its Versa Vent, and an RX-OVC vent cap is needed for outdoor installation. Follow the maker's installation manual and hire a licensed plumber where the manual says so.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Tankless Water Heater, which compares them spec by spec.

FAQ

Does a tankless water heater store hot water?

No. It heats water as it flows through the heat exchanger, and it stops when the tap closes. There is no tank to fill or keep hot.

Why does the water run cooler with two showers on?

Two taps ask for more water than one. If the total flow passes the heater's rated GPM, the water at each tap runs cooler, so check the maker's rated GPM against the taps you run together.

Can I install a tankless water heater myself?

The MIZUDO and Rinnai units recommend professional installation. Follow the maker's installation manual and hire a licensed plumber where the manual says so, since gas, venting and plumbing work needs a qualified installer.

More tankless water heaters how-tos