How-to · Tankless Water Heaters
How Fast Tankless Water Heaters Work
A tankless water heater heats water as it flows through the unit, so there is no tank to fill and no stored hot water to run out. The water still has to travel from the unit to the tap, and the flow rate decides how many fixtures can run at once. How fast it feels depends on the flow rate, the incoming water, and how many taps are open.
How the heater warms the water
Cold water enters the unit when you open a hot tap, and a burner heats it as it passes through. The heater fires only while water flows, so it stops when the tap closes. That is why there is no stored hot water to run out and no tank to refill between showers. The unit keeps heating as long as water keeps flowing and the gas supply holds.
What the flow rate means
The flow rate, in gallons per minute, says how much hot water the unit can supply at once. The Rheem supplies 7.0 gallons per minute at a 35-degree rise and the MIZUDO supplies 10.3 gallons per minute, while the Rinnai supplies 10 gallons per minute and the Westinghouse supplies 7.9 gallons per minute. A higher flow rate covers more fixtures at once, so match the figure to the showers and taps you run together.
What slows the hot water down
Cold incoming water makes the heater work harder to reach the set point, so a unit delivers less flow at a high rise than at a low rise. Opening a second shower or tap splits the flow, and each outlet gets less. Long pipe runs also add a wait at the tap, since the water in the pipes cools between uses. The MIZUDO starts heating at 0.53 gallons per minute, so a trickle below that flow stays cold.
Match the unit to your home
Count the showers and taps that run at the same time, then compare that with the maker's flow rate figure. A home with two or three showers running at once needs a higher flow rate than a home with one shower. Check the fuel the unit uses and the venting the manual calls for, then follow the maker's installation manual and hire a licensed plumber where the manual says so.
What you need
As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.
-
Rheem RTG Series 7.0 GPM Natural Gas
A natural gas tankless water heater with a 7.0 gallon per minute flow rate and 160,000 BTU output, with digital temperature control.
View on Amazon -
MIZUDO Natural Gas Tankless Water Heater
A natural gas tankless water heater with a 10.3 gallon per minute flow rate, 199,000 BTU input and app control for temperature settings.
View on Amazon -
Rinnai RX180iN Condensing Smart Sense Tankless Water
A condensing tankless water heater with a 10 gallon per minute flow rate that runs on natural gas or propane for indoor or outdoor installation.
View on Amazon -
Westinghouse Tankless Water Heater Propane Indoor
A propane tankless water heater with a 7.9 gallon per minute flow rate and 180,000 BTU output, with app and voice control.
View on Amazon
These come from our ranked list Best Tankless Water Heater, which compares them spec by spec.
FAQ
Do tankless water heaters give hot water right away?
The heater warms water as it flows, so there is no tank to heat up first. The water still travels through the pipes to the tap, so a tap far from the unit takes longer to run hot.
Can I run two showers at once on a tankless heater?
It depends on the flow rate. The Rheem covers two to three showers at 7.0 gallons per minute, while the MIZUDO covers two to three bathrooms at 10.3 gallons per minute. Count the fixtures you run together and match them to the flow rate.
Why does my hot water go cold when another tap opens?
A second tap splits the flow, so each outlet gets less hot water. Close the extra tap or run fewer fixtures at once, and check the flow rate against the fixtures you use together.




