Amazon Black Friday Week deals

Paid link

How-to · Well Pumps

How Does a Well Pump Work

Short answer

A well pump moves water from the ground to your taps. A submersible pump sits down in the well, and its impellers push water up the pipe. A jet pump sits above ground and uses suction and a venturi to pull water up, then a pressure switch starts and stops it to hold water pressure in the house.

  1. The two pump types

    Submersible pumps go down into the well, below the water. Jet pumps stay above ground, in a basement or a pump house, and pull water up through a pipe. The VEVOR and the Hallmark pumps are submersible pumps that sit in the well. The CrestWave and the Acquaer pumps are jet pumps that sit above ground and work with shallow or deep wells.

  2. How a submersible pump lifts water

    A submersible pump has a motor and a set of impellers in one body that sits in the well water. The motor spins the impellers, and each stage adds lift to push the water up the discharge pipe. The VEVOR pump has 6-stage thermoplastic impellers, a 1 HP motor, 37 GPM max flow and 207 ft max head, with a 33 ft electric cord. The Hallmark pump is a 1 HP submersible pump with 33 GPM max flow and a 1-1/4 inch NPT discharge.

  3. How a jet pump lifts water

    A jet pump sits above ground and drives water down a pipe to a venturi, also called an ejector, which creates suction that pulls well water up. A single pipe setup works for shallow wells, and a two pipe setup with an ejector kit works for deep wells. The CrestWave pump works for wells up to 26 ft on a single pipe and up to 90 ft with the ejector kit, with up to 2,330 GPH at 26 ft and 824 GPH at 90 ft. The Acquaer pump works for single pipe wells from 0 to 25 ft and two pipe wells from 26 to 90 ft.

  4. Pressure switches and overheat protection

    A pressure switch watches the water pressure in the house and starts the pump when pressure drops, then stops it when pressure is back up. The Acquaer pump starts to pump when the pressure is lower than 20 PSI and shuts off when over 40 PSI. The VEVOR, CrestWave and Acquaer pumps have overheat protection that stops the motor when it gets too hot or runs without water. Follow the maker's manual for setup, and hire a licensed electrician or plumber where the manual says so.

What you need

As an Amazon Associate I earn from qualifying purchases. Product details come from each Amazon listing; we do not test products in person.

These come from our ranked list Best Well Pump, which compares them spec by spec.

FAQ

Do I need a submersible pump or a jet pump?

It depends on your well. A submersible pump sits down in the well, and a jet pump sits above ground and pulls water up through a pipe. Check the depth your pump is made for: the CrestWave pump works up to 26 ft on a single pipe or up to 90 ft with the ejector kit.

What does head mean on a well pump?

Head is how high a pump can lift water. The VEVOR pump has 207 ft max head, and the CrestWave pump has 145 ft of vertical lift. Compare the head figure with the depth of your well before you buy.

Can a well pump run without water?

Yes, it can run without water, but you should not let it: the VEVOR pump warns not to use it without water or at a low water level. The CrestWave pump has overheat protection for dry-running, and the Acquaer pump shuts off when the water inside runs out. Follow the maker's manual so the pump does not run dry.

More well pumps how-tos